Home xin What is the reason for the origin failure of powder packaging machine

What is the reason for the origin failure of powder packaging machine

by admin

summary
Fault description: during the operation of the full-automatic powder packaging machine, the bag cutting position may have a large deviation, the gap between the bag cutting position and the color code is too large, the color code positioning fails and the photoelectric tracking compensation is out of control.
Solution: in this case, first try to readjust the position of the photoelectric switch. If not, clean the former, insert the packaging material into the lead plate, and adjust the position of the guide board so that the light spot coincides with the middle of the color code.
Consultation record · answer: what is the cause of the origin failure of the powder packaging machine on December 29, 2021? Fault description: the bag cutting position of the full-automatic powder packaging machine may have a large deviation during operation, the gap between the bag cutting position and the color code is too large, the color code positioning fails, and the photoelectric tracking compensation is out of control. Solution: in this case, first try to readjust the position of the photoelectric switch. If not, clean the former, insert the packaging material into the lead plate, and adjust the position of the guide board so that the light spot coincides with the middle of the color code. Isn’t it a circuit problem? Fault description: during the operation of the full-automatic powder packaging machine, the paper supply motor may be stuck, resulting in the motor not rotating, or the motor rotating uncontrollably due to the damage of the starting capacitor, which are very common faults. Solution: first check whether the paper supply control lever is stuck, whether the starting capacitor is damaged, and whether there is a problem with the safety tube, and then replace it according to the inspection results. Where is the starting capacitor? Everything was normal yesterday. I can’t start it this morning. It shows the origin fault. Fault 3: lax sealing fault description: the automatic powder packaging machine has lax sealing. This phenomenon will not only waste materials, but also pollute the equipment and workshop environment of the automatic powder packaging machine because the materials are powder and easy to spread. Solution: check whether the packaging containers comply with relevant regulations, remove the fake and shoddy packaging containers, and then try to adjust the sealing pressure and increase the heat sealing temperature. Fault 4: no bag pulling fault description: the full-automatic powder packaging machine does not pull the bag, and the bag pulling motor falls off the chain. The cause of this fault is nothing more than circuit problems, the bag pulling proximity switch is damaged, the controller is faulty, and the stepper motor driver is faulty. Check whether the stepping motor and the proximity switch are damaged. Fault 5: tear the packaging bag. Fault description: during the operation of the automatic powder packaging machine, the packaging container is often torn off by the automatic powder packaging machine. Solution: check the motor circuit to see if the proximity switch is damaged. Is the main engine broken? Is the main engine the motor? Yes, I can’t change the motor During the operation of the powder automatic packaging machine, there is a large deviation in the bag cutting position, and the gap between the bag cutting position and the color code is too large. The color code positioning fails and the photoelectric tracking compensation is out of control. In this case, first try to readjust the position of the photoelectric switch. If not, clean the former, insert the packaging material into the leading board and adjust the position of the guide board, Make the light spot coincide with the middle of the color code

Related Posts

Leave a Comment